Note: SnapEDA files are supported by Eagle V6 and later.

Follow these steps to import into Eagle:

  1. Open Eagle and go to the Control Panel.

  2. Expand Libraries and you’ll see the lbr folder.

  3. Locate the part you’ve downloaded from SnapEDA and drag it to the lbr folder in Eagle’s control panel.

  4. You’ll now see the new part displayed under the lbr folder, right-click and select use.

  5. The part is now ready to be used in a schematic or board

Tip: To better organize your parts in Eagle, you can right-click on the lbr folder and create a new ‘SnapEDA’ folder to store the parts you’ve downloaded from SnapEDA

Did this answer your question?