If there are some issues during installation and the SnapEDA icon is not showing on the Fusion360 tab, follow the instructions below:


***REQUIREMENT: You need to find where the plugin was installed. Most of the time it is installed in this location:

C:/Users/username/AppData/Roaming/Autodesk/ApplicationPlugins/SnapEDA.bundle/Contents.

  1. Open up Fusion360 software. Click UTILITIES > ADD-INS

  2. Click the Add-Ins tab > Click the green plus icon beside My Add-Ins

  3. Go to the directory where you saved the plugin and add the Contents folder. Once done, you will see the SnapEDA added on the My Add-Ins.

  4. Click the SnapEDA and click Run. You should now see the SnapEDA Icon.

Did this answer your question?